Fcc Compliance; Declaration Of Conformity - Epson Fast T-Jet 3 PLUS User Manual

T-Jet3 PLUS User's Manual

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING: The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certifi cation of this device and may cause
interference levels, which exceed the limits established by the FCC for this equipment.
It is the responsibility of the user to obtain and use a shielded equipment interface
cable with this device. If this equipment has more than one interface connector, do not
leave cables connected to unused interfaces. Changes or modifi cations not expressly
approved by the manufacturer could void the authority to operate the equipment.
For Canadian Users
This Class B digital apparatus complies with Canadian ICES-003.

Declaration of Conformity

According to 47CFR, Part 15 for Class B Personal Computers and Peripherals; and or
CPU Boards and Power Supplies used with Class B Personal Computers:
We: U.S. Screen Print & Inkjet Technology a division of U.S. Graphic Arts, Inc.
Located at: 1901 East 5th Street Tempe, AZ 85043 Telephone: (480) 929-2937
Declare under sole responsibility that the product identifi ed herein, complies with 47CFR
Part 2 and 15 of the FCC rules as a Class B digital device. Each product marketed
is identical to the representative Unit tested and found to be compliant with the
standards. Records maintained continue to refl ect the equipment being produced
can be expected to be within the variation accepted, due to quantity production
and testing on a statistical basis as required by 47CFR 2.909. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Version 1.1 Revised July, 2008
132