Can-Am spyder gs 2008 Operator's Manual page 99

8. Remove the bulb by releasing both
clips with a small flat head screw-
driver.
rmo2008-001-124_a
1. Bulb housing
2. Bulb retaining clip
9. Install the new bulb by clipping it to
the connector.
10. Install the connector in the bulb
housing and put the housing cap
on.
11. Install the cluster by first inserting
the bottom edge and then firmly
pushing the upper edge with both
hands.
rmo2008-001-125_a
INSTALLING CLUSTER
1. Inserting bottom edge of cluster first and
then pushing the upper edge
12. Ensure the cluster is properly in-
stalled. Repeat step 11 if neces-
sary.
Turn Signal Light – Front
1. Remove the lens with a Phillips
head screwdriver.
rmo2008-001-103_a
1. Front turn signal lens screw
2. Turn the connector counterclock-
wise as indicated below and re-
move lens.
rmo2008-001-104_a
1. Front turn signal light connector
3. Remove the bulb by pushing and
holding it while turning counter-
clockwise.
4. Install the new bulb by pushing and
turning it clockwise.
5. Properly reinstall the parts in the re-
verse order of their removal.
Turn Signal Light – Rear
1. Remove the lens with a Phillips
head screwdriver.
rmo2008-001-105_a
1. Rear turn signal lens screw
_____________________
PROBLEMS
97