Can-Am spyder gs 2008 Operator's Manual page 80

MAINTENANCE PROCEDURES
Installation
1. Screw 4 Torx screws.
NOTICE
Do not overtorque. Any
deformation on the panel around
the screw is an indication that it is
too tight. You may damage the pan-
el.
3) Rear Side Panel
Removal
1. Unlatch and lift seat.
2. Remove top side panel.
3. Unscrew Torx screws.
rmo2008-001-038_a
1. Torx screws
2. Plastic rivets
4. Remove plastic rivets as indicated
below.
rmo2008-001-077_a
1. Flat head screwdriver under rivet head
2. Turn screwdriver 1/4 turn
______________________
78
rmo2008-001-078_a
1. Flat head screwdriver under rivet
2. Turn screwdriver 1/4 turn
5. Disconnect left turn signal housing
connectors.
Installation
1. Connect left turn signal housing
connectors by matching the cor-
rect wire color.
2. Install plastic rivets and screw in
Torx screws.
NOTICE
Do not overtorque. Any
deformation on the panel around
the screw is an indication that it is
too tight. You may damage the pan-
el.
4) Lower Side Panel
Removal
1. Remove middle side panel (p. 76).
2. Remove top side panel (p. 77).
3. Remove rear side panel (p. 78).
4. Unscrew 3 Torx screws.
rmo2008-001-036_a
1. Bottom panel Torx screws
2. Screw located at the front of bottom panel
Installation
1. Screw 3 Torx screws.