Can-Am spyder gs 2008 Operator's Manual page 100

PROBLEMS
2. Remove the bulb by pushing in and
turning counterclockwise.
3. Install the new bulb by pushing and
turning it clockwise.
4. Reinstall the lens.
Tail Light/Brake Light
1. Remove the panel under the pas-
senger seat by unscrewing 7 Torx
screws as indicated below.
rmo2008-001-114_a
PANEL UNDER PASSENGER SEAT
1. 7 Torx screws location
2. Partially remove right rear side pan-
el by removing the 2 plastic rivets
under the seat as indicated below.
rmo2008-001-115_a
1. 2 plastic rivets under the seat
rmo2008-001-077_a
1. Flat head screwdriver under rivet head
2. Turn screwdriver 1/4 turn
______________________
98
rmo2008-001-078_a
1. Flat head screwdriver under rivet
2. Turn screwdriver 1/4 turn
3. Disconnect right turn signal hous-
ing connectors.
4. Remove the Torx screw behind the
lens as indicated below.
rmo2008-001-116_a
1. Removing Torx screw behind lens
5. Remove the Torx screw beside the
lens under the rear tip as indicated
below.
rmo2008-001-117_a
1. Removing Torx screw beside the lens
6. Turn the connector counterclock-
wise and remove from the lens.