Function Settings; Transmitter Handset; System Channel Settings - Magnetek FLEX-6EX Instruction Manual

4. FUNCTION SETTINGS

4.1 TRANSMITTER HANDSET

4.1.1 System Channel Settings

Set the transmitter channel by adjusting the channel dip-switch located on the backside of the
transmitter encoder board (refer to Fig. 07 above). Only the first six (6) positions are used for
channel programming (refer to Fig. 08 below). The system channels table located on page 27
illustrates which dip-switch setting corresponds to which channel. Once the transmitter channel is
altered, make sure to change the receiver channel as well. The channel on both the transmitter
and the receiver must be identical in order for the system to work. To change the receiver channel
please refer to page 19.
Example:
The above dip-switch setting "1 0 0 1 0 0" corresponds to "channel 36" in the system channels
table on page 27.
CHANNEL
1 2 3 4 5 6 7 8
(Fig. 07)
(Fig. 08)
Flex 6EX System Instruction Manual
March 2016
Page 15 of 38