Channel Change Via Push Buttons - Magnetek FLEX-6EX Instruction Manual

4.1.2 Channel Change via Push Buttons

Other than CHANNEL dip-switch on the encoder board, the transmitter channel can also be
changed directly on the push buttons. Please refer to the instructions below on how to change the
transmitter channel via push buttons.
a. Press and hold PB1, PB2 and PB3 and rotate the power key to START position at the same
time. A series of green and red blinks will appear on the Status LED showing the current
channel setting. A green blink represents the tens (+10) and a red blink represents the units
(+1).
Examples:
b. Select a new channel by pressing PB1 and PB2 on the transmitter. Press PB1 to increment
the units (+1) and PB2 to increment the tens (+10).
Examples:
c. When finished, the newly selected channel will appear on the Status LED via series of green
and red blinks again.
d. Exit the channel programming by turning off the transmitter power.
e. Make sure the receiver channel is set identical to the transmitter. Please refer to page 19
and page 22 on how to change the receiver channel.
f. Please note that when the CHANNEL dip-switch inside the transmitter is changed, the
priority will revert back to the new channel set on the CHANNEL dip-switch.
g. Please note that when the channel is set beyond channel 62 via PB1 and PB2 (i.e. channel
63, 68, 88, etc....), the system will recognize it as channel 62.
2 green blinks followed by 5 red blinks represents channel 25.
6 red blinks represents channel 06.
Press PB2 two times and then PB1 four times will give you channel 24.
Press PB1 nine times with give you channel 09.
Flex 6EX System Instruction Manual
March 2016
Page 16 of 38