Troubleshooting - Ruijie RSR10-01G Hardware Installation Manual

Installation Manual
5
5.1 Troubleshooting Power Faults
For RSR10-01G series, you can determine whether the power s
PWR indi
on the first chapter. If any abnormal situations
If the router power switch is in the on position.
If the power supply switch of the router is in the on position.
If the
If the p
W arning
5.2 Trou bleshooting Configuration
Faul ts
After the router is powered on, the terminal will show the startup messages described in
Ch pter 4 if the system is normal. If the con a
no messages or illegible codes.
If the terminal does not display any messages, please make the following checks:
Whether the power system is normal.
Whether the Console cable is properly connected.
If the steps above did not solve your problem, it is likely because of wrong configuration
cable or wrong terminal parameter setting. Please check terminal parameters.
If illegible codes occur on the terminal, the possible cause is that terminal parameters
config ured
b its ; no pa
Note
cator on the front panel. For the normal
po wer cable is connected correctly.
ower supply meets the requirements.
If the check shows ever
please contact the local distributor or technical support team.
do not match. Please check the termi
rity check; 1 stop bit; no flow control; VT100 for simulation terminal.
When the console port parameters of your router are modified, this may also
lead to no display on the terminal.

Troubleshooting

status of the indicato
occur, please make the following checks:
ything is normal but the SYS/PWR indicator is still off,
figuration system fails, the terminal may display
nal parameters: baud rate of 9600; 8 data
Chapter 5 Troubleshooting
ystem has any fault by the
r, see the description
5-1