Installing The Power Cable And Grounding Cable; Connecting The Console - Ruijie RSR10-01G Hardware Installation Manual

Installation Manual
3.3 Insta lling the Power Cable and
Grou nding Cable
Ruijie RSR10-01G routers support this AC power supply.
Power adapter: Input AC: 100–240V; 50-60Hz
Make sure that your power
The power cable of the router is composed of three wires. You are recommended to use a
single-phase power socket with a neutral connector or a multifunctional PC power socket.
The neutral point of the power supply should be reliably grounded in the building. For
common buildings, the ne
a nd wiring. You must verif
3.4

Connecting the Console

Ruijie
c onfiguration.Through t
Configuration attributes:
Connector
Interface standard
Baud rate
Supported services
T o conne
Connect one end of the supplied configuration cable to the RJ45 console port of the router
and the other to
SuperTerminal is running on the PC.
Output DC: 12V/1.25A
supply meets the requirement.
utral points have been buried into the ground during construction
y if the power supply of the building has been properly grounded.
serie s router s sup ply
his inte rface, user can complete the local configu
ct the console port of the router:
the DB-9 male connector used to configure the router. Please verify that a
an EIA/TIA-232
RJ-45
Asyn EIA/TIA-232
The default is 9600bps.
1. Command line interface
2. Connection to the character terminal
Chapter 3 Installing Router
co nfiguration console
ration of the routers.
for local
3-3