Routine Testing; Daily Check - Fault Indicators; Weekly Functional Test; Six Monthly Inspection By A "Competent Person - Baldwin Boxall OmniCare Installation Manual

Evc system
Table of Contents

Advertisement

OmniCare EVC System
Installation & Commissioning Manual
7.2 R
OUTINE

7.2.1 Daily Check - Fault Indicators

7.2.2 Weekly Functional Test

7.2.3 Six Monthly Inspection by a "Competent
86
T
ESTING
If the OmniCare EVC System Control Panel is located in a
position where the audible fault warning could be unnoticed for
more than 24 hours, a special check should be performed each
day to confirm that either the "System OK" LED is illuminated,
or any faults that are indicated are receiving necessary attention.
N
: This Check only needs to be performed if the Warning Buzzer may
OTE
go unheard for 24 hours.
This inspection does not need to be recorded.
Each week, a functional test of a Remote Unit should be
performed to ensure it can make and receive clear and intelligible
calls to the relevant Control Panel(s).
A different Remote Unit should be used each week, so that all
units will get tested in rotation.
N
: The result of this weekly test and the identity of the Remote Unit
OTE
used should be recorded.
Person"
The Standard recommends that every six months the System
should be thoroughly inspected to ensure continued reliability.
The "Competent Person" must have suitable knowledge and
equipment to be able to check the system.
Baldwin Boxall can perform these Inspections under a Service
Agreement.
N
: The result of this inspection and any outstanding defects will be
OTE
reported to the "Responsible Person". These should be recorded.
C O M M U N I C A T I O N S
OmniCare issue 1

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Baldwin Boxall OmniCare

Table of Contents