Connecting Batteries - Baldwin Boxall OmniCare Installation Manual

OmniCare EVC System
Installation & Commissioning Manual

4.4.3 Connecting Batteries

54
Connecting the batteries to the Control Panel should only be
performed after the wiring checks in Section 4.4.1 and Section
4.4.2 have been completed successfully.
N : If this procedure is not followed the Control Panel may display a
OTE
"Charger Fault".
1. Disconnect the Mains Power from the Control Panel.
Wait for 10 seconds.
2. Connect the Batteries to the Control Panel.
N : THE BATTERIES MUST BE CONNECTED BEFORE
OTE
THE MAINS POWER.
3. Re-connect the Mains Power to the Control Panel,
4. Press the "RESET" button to remove the "PROCESSOR
RESTART" fault LED.
5. The Green "System OK" LED should now illuminate.
N : The Control Panel will not operate on Batteries until the Mains
OTE
Power has been applied.
C O M M U N I C A T I O N S
OmniCare issue 1