Configuring Remote Units; Re-Addressing Remote Units - Baldwin Boxall OmniCare Installation Manual

C O M M U N I C A T I O N S
5.3 C
5.4 R
OmniCare issue 1
ONFIGURING
To configure a Remote Unit using the Tone Generation software
use the following procedure:
1. Select the type of Remote Unit,
2. Select the option(s) required,
3. Enable the "Configuration Mode" of the Remote Unit:
• BVOCECP - press and hold the "Call" button until a
tone is heard,
• BVOCA - double tap the "Call" button and a tone should
be heard,
• BVFHL - double tap the handset "on - hook" switch and
a tone should be heard,
• BVOCRFC - press and hold the "Call" button until a
tone is heard.
4. The configuration software will detect the tone generated by
the Remote Unit and will then play the correct sequence of
tones.
5. If the configuration is succesful the Remote Unit will play a
tone back to the configuration software as confirmation.
-
E ADDRESSING
Remote Units can be re-addressed so they appear at different
locations on the Control Panel(s).
Care must be taken when re-addressing Remote Units to ensure
that there are no duplicated addresses.
To re-address a Remote Unit select the address from the drop
down list and then follow the procedure described in section 5.3.
R U
EMOTE NITS
R U
EMOTE
OmniCare EVC System
Installation & Commissioning Manual
NITS
67