Zone Control Panels - Baldwin Boxall OmniCare Installation Manual

C O M M U N I C A T I O N S

3.3.3 80 - 128 Zone Control Panels

OmniCare issue 1
Figure 3.19 — Mounting Hole Centres and Knockout Positions
N : The weight of a Control Unit with batteries is 37KG.
OTE
Ensure the wall or mounting point is of sufficient strength to support the
weight of the unit.
1. Open the glazed door and remove the M6 screws from the
right-hand side of the control panel.
2. To allow access to the two top locating holes in the rear of the
unit, remove the two M6 locating screws from the upper
Termination Panel and drop it down.
3. Fit the Control Panel to the wall using suitable fixings.
The panel is designed for either surface mounting (using the
4 off 9mm holes shown in Figure 3.19), or it can be flush
mounted using an optional bezel.
OmniCare EVC System
Installation & Commissioning Manual
43