Advance Refuge Remote (Bvoca) - Baldwin Boxall OmniCare Installation Manual

OmniCare EVC System
Installation & Commissioning Manual

4.5.3 Advance Refuge Remote (BVOCA)

56
3. Set the Volume on the
The volume control (as shown in Figure 3.2 on page 21) sets
the level of Control Panel speech (and the level of the ring
tone) reproduced at the
to allow speech to be clearly understood.
4. De-occupy the unit by turning the Keyswitch clockwise 45°
and then returning it to vertical. Ensure both the "STATUS"
LED on the front panel and the relevant Zone LED on the
Control Panel extinguish.
1. Ensure all 8 LEDs are flashing to indicate the system is active
and ready to make a call.
N : If only the Top Centre LED is flashing then the Fire Panel input
OTE
is not active and the Remote Unit will not be able to make a call.
2. Press the centre "CALL" button.
Ensure all 8 LEDs surrounding the button stop flashing.
3. Both the Remote Unit and the Control Panel(s) will 'ring'.
The associated red LED on the Control Panel(s) will flash to
indicate activity at that Remote Unit location.
Check that when the handset is lifted and the zone is selected
communication can be established.
N : If only one Remote Unit is calling the Control Panel then that call
OTE
is automatically answered by lifting the handset.
4. Set the Volume on the
The volume control (as shown in Figure 3.5 on page 27) sets
the level of Control Panel speech (and the level of the ring
tone) reproduced at the
to allow speech to be clearly understood.
5. De-occupy the unit by pressing and holding the "CALL"
button until a tone is heard.
After releasing the button ensure the 8 LEDs flash to indicate
another call can be made and the relevant Red LED is
extinguished on the Control Panel(s).
.
Remote Unit
and should be adjusted
Remote Unit
.
Remote Unit
and should be adjusted
Remote Unit
C O M M U N I C A T I O N S
OmniCare issue 1