Table of Contents
Advertisement
Mechanical Disassembly
Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
z Cabinet Top, Front, R/C Board removal
1. Remove 5 screws A(Tx10) to remove the cabinet top.
2. Remove 2 screws B(M2.5X6) and 2 screws C(Tx8) to
remove the Cabinet front.
. Remove screw D(M2.5x6) and 2 screws E(T2x6) to
remove the Cabinet front shield.
4. Remove 2 screws F(T2x8) to remove the
Antenna board.
5. Remove screw G(T2x8) to remove the R/C Board.
6. Remove 4 screws H(Tx8) to remove the Lens cap
base and slide shutter.
Antenna Board
R/C Board
G (T2x8)
DEC Inlay LED front
Lens cap base
B
Slide shutter
C
Cabinet front
A
F (T2x8)x2
D (M2.5x6)
F
H (Tx8)x4
H
E
H
E (T2x6)X2
H
Cabinet front shield
B (M2.5x6)x2
C (Tx8)x2
Decoration LED
-12-
Screws Expression
(Type
Diameter x Length
T type
M Type
A (Tx10)x5
Cabinet top
A
Control Buttons
A
Fig.1
) mm
A
Advertisement
Table of Contents
