Technical note: Sony cameras on DIVAR network
Using Sony ONVIF cameras on DIVAR network recorders
Basic DIVAR network configuration
Configuring VMD & streaming on Sony cameras
DIVAR App, configuring streaming on Sony cameras
DIVAR Network 2000/3000/5000 Firmware 1.2.1 or later.
Sony IP camera 600 series Firmware V2.8 or later (refer to supported device list at the end of
Windows™ PC (Windows 7 or later). **
SNC-Toolbox software V188.8.131.52 or later. **
DIVAR mobile APP (optional)
Installation: (DIVAR network 2000/3000/5000 with PoE)
A USB mouse and a display should be connected to the DIVAR.
Connect the cameras to the DIVAR network and power up the unit.
The cameras receives power from the DIVAR and take about 90 seconds to boot, after the
DIVAR unit has powered up.
When the DIVAR has booted, follow the steps
in the wizard, see next page.
** Items are required to configure VMD
and streaming in the Sony network camera
8 November 2017
Page 1 of 11