Rebooting From Remote Locations; Packet Capture; Multicast Paging; Figure 4: Packet Capture In Idle - Grandstream Networks GXP1760 Administration Manual

Rebooting from Remote Locations

Press the "Reboot" button on the top right corner of the web GUI page to reboot the phone remotely. The
web browser will then display a reboot message. Wait for about 1 minute to log in again.

Packet Capture

GXP1760/GXP1780/GXP1782 is embedded with packet capture function on firmware 1.0.0.38 or greater.
The related options are under Maintenance -> Packet Capture.
Users need to choose first the capture location either the internal storage or the connected USB and then
press Start button to start packet capture. Press Stop to end capture.
User can press Download button to download capture file to local PC.
Note:
- User can also define whether RTP packets will be captured or not from With RTP Packets option.
- USB Filename is only required for USB and it defines the capture filename.

Multicast Paging

GXP1760/GXP1780/GXP1782 supports multicast paging, including sending and listening. On the phone,
users could send multicast page by setting the multicast address and port. Also, users can listen to at
most 10 different multicast IP address.
Multicast sender related settings are under Web UI, Settings -> Programmable keys. Select Multicast
paging as the key mode for dial page call. Multicast paging listening related settings are under Web UI
Settings -> Multicast Paging.

Figure 4: Packet Capture in Idle

GXP17xx Administration Guide
P a g e | 53