Settings Page Definitions; Table 7: Settings - Grandstream Networks GXP1760 Administration Manual

If set to "Yes", the "Refer-To" header uses the transferred target's Contact
Refer-To Use Target
Contact header information for attended transfer. The default setting is "No".
Transfer on If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties will
Conference Hang-
up remain in the conference call. The default setting is "No".
Disable Recovery Disable recovery to the call to the transferee on failing blind transfer to the
target. The default setting is "No".
on Blind Transfer
Defines the timeout (in seconds) for no key entry. If no key is pressed after the
No Key Entry
timeout, the digits will be sent out. The default value is 4 seconds. The valid
Timeout (s)
range is from 1 to 15.
Allows users to configure the "#" key as the "Send" key. If set to "Yes", the "#"
key will immediately dial out the input digits. In this case, this key is essentially
Use # as Dial Key equivalent to the "Send" key. If set to "No", the "#" key is included as part of the
dialing string and please make sure the dial plan is properly configured to allow
dialing # out. The default setting is "Yes".
Account x  Feature Codes
When enabled, Do Not Disturb, Call Forwarding and other call features can be
used via the local feature codes on the phone. Otherwise, the provisioned
Enable Local Call feature codes from the server will be used. User configured feature codes will
Features be used only if server provisioned feature codes are not provided. And once
feature codes are configured, either via server provisioning or local setting, a
softkey named "Features" will show on the LCD screen.
Do Not Disturb
Configures DND feature code to turn on DND.
(DND)--On
Do Not Disturb
Configures DND feature code to turn off DND.
(DND)--Off
Delayed Call Defines the timeout (in seconds) before the call is forwarded on no answer. The
default value is 20 seconds. The valid range is 1 to 120.
Forward Wait Time

Settings Page Definitions

Settings  General Settings
This parameter defines the local RTP port used to listen and transmit. It is the
base RTP port for channel 0. When configured, channel 0 will use this port _value
Local RTP Port
for RTP, channel 1 will use port_value+2 for RTP. Local RTP port ranges from
1024 to 65400 and must be even. The default value is 5004.
Forces random generation of both the local SIP and RTP ports. This is usually
Use Random Port necessary when multiple phones are behind the same full cone NAT. The default
setting is "Yes".
Table 7: Settings Page Definitions
GXP17xx Administration Guide
P a g e | 31