Settings of the cooling fan transformer
The voltage transformer of the cooling fan is located at the top right-hand corner of
the drive module. Remove the front cover for adjusting the settings and replace the
cover after setting.
Installation of optional modules
The optional module (such as a fieldbus adapter, an I/O extension module and the
pulse encoder interface) is inserted in the optional module slot of the RMIO board in
the RDCU unit and fixed with two
manual for the cable connections.
Cabling of I/O and fieldbus modules
Strain relief with
a cable tie
Set to 220 V if the supply frequency is 60 Hz. Set to
230 V if the supply frequency is 50 Hz.
Set according to the supply voltage:
380 V, 400 V, 415 V, 440 V, 480 V or 500 V; or
525 V, 575 V, 600 V, 660 V or 690 V.
Note: No need to set for 230 V units.
screws.
Grounding wire of the outer shield
Alternative to a)
As short as possible
1
2
3
4
a)
Module
See the appropriate optional module
63
Electrical installation