Requirements Table - ABB ACS800-04 Hardware Manual

36

Requirements table

The following table shows how to select the motor insulation system and when an optional ABB du/dt
filter, insulated N-end (non-driven end) motor bearings and ABB common mode filters are required. The
motor manufacturer should be consulted regarding the construction of the motor insulation and
additional requirements for explosion-safe (EX) motors. Failure of the motor to fulfil the following
requirements or improper installation may shorten motor life or damage the motor bearings and voids
the warranty.
Motor type Nominal mains
voltage (AC line
A Random- U < 500 V
N
wound M2_
B
500 V < U
and M3_
B
600 V < U
Form-wound 380 V < U
HX_ and AM_
Old* form- 380 V < U
wound HX_
and modular
Random- 0 V < U
wound HX_
500 V < U
and AM_ **
Planning the electrical installation
Motor insulation
voltage)
system
Standard
< 600 V Standard
N
or
Reinforced
< 690 V Reinforced
N
< 690 V Standard
N
< 690 V Check with the
N
motor
manufacturer.
< 500 V Enamelled wire
N
with fibre glass
< 690 V
N
taping
Requirement for
ABB du/dt filter, insulated N-end bearing and ABB common mode
P < 100 kW 100 kW < P
N
and
frame size > IEC 315
frame size < IEC 315
P < 134 HP 134 HP < P
N
and frame size <
NEMA 500
- + N
+ du/dt + du/dt + N
- + N
+ du/dt + du/dt + N
n.a. + N + CMF
+ du/dt with voltages over 500 V + N + CMF
+ N + CMF
+ du/dt + N + CMF
filter
< 350 kW P
N N
or
frame size > IEC 400
< 469 HP P
N N
or frame size > or frame size >
NEMA 500 NEMA 580
+ N + CMF
+ du/dt + N + CMF
+ N + CMF
+ du/dt + N + CMF
P < 500 kW: + N +
N
CMF
P > 500 kW: + N +
N
CMF + du/dt
> 350 kW
or
> 469 HP