Resistor Braking; What This Chapter Contains; To Which Products This Chapter Applies; Availability Of Brake Choppers And Resistors For The Acs800 - ABB ACS800-04 Hardware Manual

Resistor braking

What this chapter contains

This chapter describes how to select, protect and wire brake choppers and resistors.
The chapter also contains the technical data.

To which products this chapter applies

This chapter applies to the ACS800-01/U1 (frame sizes R2 to R6), ACS800-02/U2
(frame sizes R7 and R8), ACS800-04/U4 (frame sizes R7 and R8) and ACS800-07/
U7 (frame sizes R6, R7 and R8).

Availability of brake choppers and resistors for the ACS800

Frame R2 and R3 drives and 690 V units of frame size R4 have a built-in brake
chopper as standard equipment. For other units, brake choppers are optionally
available as built-in units, indicated in the type code by +D150.
Resistors are available as add-on kits. For the ACS800-07/U7, resistors are
available as factory installed.

How to select the correct drive/chopper/resistor combination

1. Calculate the maximum power (P
2. Select a suitable drive / brake chopper / brake resistor combination for the
application according to the following tables (take account of other factors in the
drive selection also). The following condition must be met:
where
P
3. Check the resistor selection. The energy generated by the motor during a 400-
second period must not exceed the resistor heat dissipation capacity E
If the E
resistors are connected in parallel, two in series. The E
times the value specified for the standard resistor.
P > P
brcont max
denotes P , P
br br5 br10
value is not sufficient, it is possible to use a four-resistor assembly in which two standard
R
) generated by the motor during braking.
max
, P , P , or P depending on the duty cycle.
br30 br60 brcont
value of the four-resistor assembly is four
R
107
.
R
Resistor braking