Ul/Csa Markings; Equipment Warranty And Liability - ABB ACS800-04 Hardware Manual

106

UL/CSA markings

The ACS800-04, ACS800-U4 and ACS800-04M are C-UL US listed and CSA marked. The approval is
valid with rated voltages (up to 600 V).
UL
The drive is suitable for use on a circuit capable of delivering not more than 100 kA rms symmetrical
amperes at the drive nominal voltage (600 V maximum for 690 V units) when protected by fuses given
in the
The drive provides overload protection in accordance with the National Electrical Code (US). See
ACS800 Firmware Manual for setting. Default setting is off, must be activated at start-up.
The drives are to be used in a heated indoor controlled environment. See section
for specific limits.
Brake chopper - ABB has brake choppers that, when applied with appropriately sized brake resistors,
will allow the drive to dissipate regenerative energy (normally associated with quickly decelerating a
motor). Proper application of the brake chopper is defined in chapter

Equipment warranty and liability

The manufacturer warrants the equipment supplied against defects in design, materials and
workmanship for a period of twelve (12) months after installation or twenty-four (24) months from date
of manufacturing, whichever first occurs. The local ABB office or distributor may grant a warranty period
different to the above and refer to local terms of liability as defined in the supply contract.
The manufacturer is not responsible for
• any costs resulting from a failure if the installation, commissioning, repair, alternation, or ambient
conditions of the drive do not fulfil the requirements specified in the documentation delivered with
the unit and other relevant documentation.
• units subjected to misuse, negligence or accident
• units comprised of materials provided or designs stipulated by the purchaser.
In no event shall the manufacturer, its suppliers or subcontractors be liable for special, indirect,
incidental or consequential damages, losses or penalties.
This is the sole and exclusive warranty given by the manufacturer with respect to the equipment and is
in lieu of and excludes all other warranties, express or implied, arising by operation of law or otherwise,
including, but not limited to, any implied warranties of merchantability or fitness for a particular purpose.
If you have any questions concerning your ABB drive, please contact the local distributor or ABB office.
The technical data, information and specifications are valid at the time of printing. The manufacturer
reserves the right to modifications without prior notice.
Technical data
NEMA data fuse table. The ampere rating is based on tests done according to UL 508C.
Ambient conditions
Resistor braking.