Ip Streaming - Canon EOS C700 Instruction Manual

IP Streaming

IP Streaming
When the main recording mode is set to [XF-AVC (CFast)], after you connect the camera to a network (Wi-Fi
(Infrastructure) or wired (Ethernet)), you can stream the camera's live video and audio* over IP to a compatible IP
178
video decoder** connected to the network. You can use IP streaming for live broadcasts or to send a news flash
report from a location with poor network connectivity, since the configuration of streamed video is lower (so the
data to be transferred is smaller) than that of recorded clips.
* Only 2 channels. When recording main recording clips with 4 audio channels, you can select which two channels to stream over
IP.
** This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders,
please visit your local Canon Web site.
Configuration of video streamed over IP
Main recording
resolution and frame rate
3840x2160
(59.94P or 50.00P)
1920x1080
(59.94P, 59.94i, 50.00P, 50.00i)
Preparations
Before you can stream video over IP, you need to configure settings related to the transfer like the protocol and
port number to use. You can also select the configuration of the streamed video.
Camera and Receiver Settings
1 Connect the camera to a network.
• Use an Ethernet network (A 164) or a Wi-Fi network in Infrastructure mode (A 161).
2 Open the IP streaming settings submenu.
Setup screen:
Monitoring menu:
3 Select the video configuration for the video streamed over IP.
[Video Output Conf.] > Desired option > Press SET
4 Select the audio channels for the IP stream.
[Audio Out Channels] > [CH1/CH2] or [CH3/CH4] > Press SET
5 Select the protocol to be used.
[Protocol] > Desired option > Press SET
• If you selected [RTP+FEC], complete the error correction settings with the following procedure (A 179).
• If you selected [RTSP+RTP], configure the RTSP user name and password with the following procedure
(A 179). Otherwise, continue this procedure to configure the receiver's settings.
6 Select [Dest. IP Address] and then press SET.
• Enter the IP address using the keyboard screen (A 37).
• Setup screen only: Press [RESET] to reset the IP address to [0.0.0.0].
7 If necessary, select [Dest. Port No.] and press SET.
• Enter the port number using the keyboard screen (A 37).
Bit rate (VBR)
9 Mbps 1920x1080
4 Mbps 1920x1080
2 Mbps
1.5 Mbps
[NETWORK] > [IP Streaming] > [OPTIONS]
[System Setup] (B) > [Network Settings] > [IP Streaming]
Streamed signal
Video
Resolution Frame rate
59.94i, 50.00i
1280x720 29.97P, 25.00P
720x480 59.94i
720x576 50.00i
Audio
Format Bit rate
MPEG-2 AAC 2ch 256 Kbps