Electrolux T4530 Service Manual page 54

54
E 14 - Gas error, push gas reset button
Error description
When the ignition control fails to detect a flame, a signal is sent to the
PCB, and error code E14 is displayed.
The metal probe of the flame sensor generates an electrical current
when exposed to the burner's flame.
This signal is detected by the ignition control module which, in turn,
cuts off the gas valve immediately if the sensor does not indicate flame
within 5 sec.
The integrity of the sensor's electrical connection is, therfore, critical to
proper operation of this system.
Displaying error code E14
USA and Japan: The error code is not displayed until the 3rd
unsuccessful ignition attempt.
Europe: The error code is displayed at the 1st unsuccessful ignition
attempt.
Error analysis
See next page.
Check that air supply to the room and ventilation are compliant with the
recommendations given in the installation manual.
Resetting
Resetting is done by pushing the gas reset button on the circuit board.
Japan only: By opening and closing the door (coin operated dryers
only).
Troubleshooting