Example 2: Operation In Speed Mode - Using Accessory Ean 1 - With Position Control Done By External Device (Cnc, For Example) - WEG SCA06 User Manual

Energizing and Start of Operation
Sequence
Press the key
8
servomotor must be spinning according to the
programmed speed.
Program the desired speed and press the key
9
to save the content.
Press the key
10
P00099.
6
Press the key
11
parameter P00099.
Press the key
that is, it will be disabled. Whenever P00099
12
is enabled, the motor will spin at the speed
programmed in P00121.
6.2.2 Example 2: Operation in Speed Mode - Using Accessory EAN 1 - With Position Control Done by
External Device (CNC, for example)
Parameters to be set:
Set password
P00000 = 5
Program motor
P00385 = according to available model
Program operating mode
P00202 = 2
Program DI1 for enabling
P00300 = 1
Program Error via DO1
P00280 = 6
Program speed reference via AI2
6-6 | SCA06
Action / Result
to increase the speed. The
until you reach parameter
to enter the content of
. Then the motor will stop,
Figure 6.3: Sequence to enable the servomotor
Indication on the Display