Name Of Functions Of Main Parts; Set The Station No. And Baud Rate; About Indicator Of Led - Toshiba TOSVERT VF-AS1 Function Manual

3. Name of functions of main parts

3.1. Set the station No. and baud rate

For the setting station number or communication speed to take effect, power needs to be
turned off and then turned back on.
Set the Station No.
1.
Set the inverter station number before switching on the inverter and do not change the
setting while power is on.
The station number can be set between 1 and 64.
The switch x10 is set up the ten's place and x1 is set up the ones.
Set the arrow (↑) of the corresponding switch to the required numeral.
*The station number changed while powering on the inverter is not made valid.
*Set the station numbers consecutively in a connection sequence.
(The station numbers may be also set independently of the connection sequence.)
*Note that the same station number cannot be regarded.
(If the same station number is repeated, proper communication cannot be made.)
*Set each station number switch to the position of its numeral securely. If it set to any
position between numerals, normal data communication cannot be made.
2. Setting the communication speed
*It causes an error when the switches are not set correct position (ex. set position
between 0 and 1 switch label), or set over 5.
Set the communication baud rate switch same as the master unit.

3.2. About indicator of LED

The LED shows the present status of the network and error.
Refer to this manual [6.3. How to check the error using the LEDs].
※
C
C
I
L
i
n
k
x10 x1
SW 0
Baud rate 156kbps
POWER Light on during power on.
L.RUN Light on during communication.
SD Light on during send the data of CC-Link.
RD Light on during receive the data of CC-Link.
L.ERR Light on during communication error.
BAUD RATE
1 2
625bps 2.5Mbps
4 −
−
E6581288①
3 4
5Mbps 10Mbps