Installation - Honda HRM300/500 Owner's Manual

Installation

Installation
We strongly recommend that an authorised Honda dealer performs the installation of your Robotic
Lawnmower. Installation by an authorised Honda dealer will ensure that your system is working correctly.
Checking conditions for installation
Check with the dealer that performed the installation if the docking station and boundary wire are installed
according to the conditions below. Also periodically confirm that these conditions are still met.
If any of these conditions are not met, consult your dealer.
It is recommended that the mains power supply is professionally installed in line with local laws and
regulations.
Conditions for installing the docking station
5° (8.7%)
5° (8.7%)
CW-direction
wire
ACW
Type 1
ACW
Type 3
12
Image
ACW
Type 2
ACW
Type 4
CW
3 m
2.5 m 2.5 m
5° (8.7%) The docking station must be installed at an
inclination of no more than 5° (8.7%).
5° (8.7%)
The docking station must not be curved.
The screws must be firmly tightened.
• The connection location for setting CW or
ACW must be correct.
• The signal position connection must be the
same as that set in the menu.
ACW
• The boundary wire must extend in a straight
line 2.5 m from both the front and rear of the
docking station.
• There must not be foreign objects within the
work area near the docking station (in the
shaded area indicated in the image).
The boundary wire under the docking station
must be laid toward the outside of the work
area.
Condition