Front Panel - Everlast POWERARC 300ST Operator's Manual

Analog dc stick/dc tig igbt inverter welder
Table of Contents

Advertisement

Section 2
ON INDICATOR
DIGITAL AMP METER
LIFT TIG/STICK SWITCH
DUTY CYCLE INDICATOR
OVER CURRENT INDICATOR
NEGATIVE (-) STANDARD CONNECTOR
Note: The unit cannot strike an arc if both the electrode holder and the work clamp are engaged in the two
negative (left and middle) ports. To work, either the electrode holder connector or the work clamp connector must
be engaged in the far right positive (+) connector with the other engaged in one of the two negative ports. Most
electrodes require reverse polarity. To maintain reverse polarity (also known as positive polarity or DCEP+) the
work clamp should be engaged in one of the two negative (-) ports, and the electrode holder should always be in
the positive port. When required, negative polarity may be used, and the electrode holder should then be en-
gaged in one of the two negative ports and work clamp will be moved to the positive port. Consult electrode manu-
facturer data and/or instructions for polarity recommendations and specific amp requirements. Electrode instruc-
tions are usually found attached to electrode container or box. If not, consult the electrode manufacturer's online
resources and specifications for more specific information.
PowerARC 300ST
Front Panel View
NEGATIVE (-) 6010 CONNECTOR
GENERAL SETUP AND OPERATION
6010
12
AMP/CURRENT CONTROL
ARC FORCE CONTROL
HOT START CONTROL
POSITIVE (+) CONNECTOR

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents