Lift Tig Configuration - Everlast POWERARC 300ST Operator's Manual

Section 2 GENERAL SETUP AND OPERATION
PowerARC 300ST
TIG WELDING CONFIGURATION
Gas Valve
6010
WORK (+)
TORCH (-)
NOTE: The TIG torch will always be used in the far left negative terminal. Do not use the negative E 6010 Terminal or in the positive terminal.
TIG torch and regulator are optional items and must be purchased separately. In this type of lift start configuration, the torch
will always be live. There is no foot pedal or torch switch to activate the TIG torch power. You must purchase a torch with a
gas valve to control the gas flow. The unit does not contain a gas solenoid valve to regulate pre-flow or post flow. A regula-
tor is still needed to regulate max flow. To connect Everlast torches, some adaptation or modification of the torch gas line
will be needed, as is the case with most gas valve torches to connect directly to the regulator. The fittings needed to couple
the torch to the regulator are stocked in most well equipped welding supply stores, and hardware stores. This can be ac-
complished inexpensively in several different ways using different types of fittings, depending upon the user requirements.
17