Barco R9002380 Installation Manual page 19

To start the checking procedure :
1. Switch on the projector
2. Press ADJUST to start up the adjustment mode (menu 1).
3. Push the cursor key é or ê to select 'Service' (menu 1)
4. Press ENTER.
The service menu will be displayed (menu 2).
5. Push the cursor key é or ê to select 'PROJECTOR SET UP'
6. Press ENTER.
The Projector Set up menu will be displayed (menu 3).
7. Push the cursor key é or ê to select 'IDENTIFICATION'
8. Press ENTER.
The Identification screen will be displayed (menu 4). On this screen, information is given about the projectors configuration.
Configuration when leaving the factory : ceiling/front configuration.
ADJUSTMENT MODE
Select a path from below :
IRIS
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
5976067 BARCOCINE 7 151299
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
COMMON ADDRESS : 0
BARCO LOGO
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 3
Installation Guidelines
CINE 7
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
menu 4
3-7