How To Assemble Your Ceiling Fan Blades - Fanimation HUGH 44 Instructions Manual

1. Assemble the motor assembly to ceiling bracket
using the previously removed screws and securely
tighten all screws. (Figure 1)
2. Push the canopy trim ring up to conceal the screws,
such that the mounting tabs seat into the dimpled
grooves in the ceiling bracket midway between the
screws. (Figure 2)

How to Assemble Your Ceiling Fan Blades

1A. For FPS8332
Slide blades through slots in motor housing and attach
to the motor hub using the #8-32 serrated head screws
and flat washers. Make sure the screws securing
the blades to the motor hub are tight and are properly
seated. ( Figure 1A)
1B. For FPS8355
Slide blades through slots in motor housing and attach
to the motor hub using the #8-32 serrated head screws
and blade plate. Make sure the screws securing the
blades to the motor hub are tight and are properly
seated. ( Figure 1B)
NOTE:
Periodically check blade hardware and
resecure if necessary.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
How to Assemble Your Ceiling Fan
Dimpled
Groove
Mounting
Tabs(4)
Motor
#8-32
Serrated Head Screws
and Flat Washer
(3 each per blade)
FPS8332
#8-32
Serrated Head
Screw
FLAT WASHER
Motor
#8-32
Serrated Head Screws
(3 each per blade)
FPS8355
#8-32
Serrated Head
Screw
BLADE PLATE
9
Ceiling Bracket
Assembly
Motor
Assembly
Figure 1
Canopy Trim
Figure 2
Ring
Figure 1A
HARDWARE USED:
x 9
x 9
Blade Plate
Figure 1B
HARDWARE USED:
x 9
x 3
Blade
Blade