How To Wire Your Ceiling Fan- Wall Conrtol - Fanimation HUGH 44 Instructions Manual

How to Hang Your Ceiling Fan (continued)
4. Hang the Motor Assembly as shown. (Figure 5)
You can now proceed with the electrical wiring of
your fan.
How to Wire Your Ceiling Fan - Wall Control
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by
a licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricityis
turned off at the main fuse box before wiring (Figure 1).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
NOTE: Please set all knobs on the fan/light control in the
off (0) position before wiring.
1. Disconnect the power and remove the existing
wall plate and switch.
2. Set the knob and light switch of the wall-mounted
control in the off (0) position.
3. Make wire connections and secure with wire nuts
supplied. (Figure 2)
Connect the Black wire (AC IN L) from the
wall-mounted control with the wire from the A. C.
power supply.
Connect the Black wire (To Motor L) from the
wall-mounted control with the Black wire from the
ceiling fan.
Connect the White wire from the ceiling fan to
the A. C. power supply.
Connect the Blue wire (To Light) from the
wall-mounted control with the Blue wire from the
ceiling fan.
Connect the green/yellow wire from the
wall-mounted control with ceiling fan and ground wire
from the A. C. power supply.
Ceiling Bracket
Assembly
NOTE: Supply wires
omitted for clarity
Black
120V AC
Ground
SUPPLY
SOURCE
White
Green
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan unless blades are in place. Noise and fan damage
could result.
7
Figure 5
MAIN FUSE BOX
Figure 1
AC IN L
To Light
To Motor L
Black
Blue
Figure 2
WARNING
Motor
Assembly