How To Assemble Your Ceiling Fan Blades - Fanimation SLINGER LP8147SLBN Manual

NOTE: This step is applicable after the necessary wiring
is completed.
1. Assemble canopy by rotating key slot in canopy over
shoulder screw in hanger bracket
the wires. Tighten shoulder screw. Fully assemble and
tighten second shoulder screw that was previously
removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

1. Lay the blade holders with the threaded posts and
pitched foot facing up. Position the blades over the
blade holders with the threaded posts showing. Make
sure the bottom edge of the blades is fully seated
against the blade holders. Place blade covers on top
of the blades, positioning the holes over the threaded
posts. Tighten serrated head screws to secure the
blades to the blade holders. (Figure 1)
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the hub of motor
NOTE: Periodically check blade holder hardware and
resecure if necessary.
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
e lectrical supply circult to the fan before installing
light kit.
How to Install Your Canopy Housing
and care not to pinch
WARNING
Blade Cover
Blade Holder
HARDWARE USED:
3/16˝-24
Serrated Head
Screw
HARDWARE USED:
1/4˝-20
Pan Head
Screw
12
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
3/16˝-24 Serrated Head
Screw (3 each per blade)
Blade
Figure 1
x 27
1/4˝-20
Pan Head Screw
(3 per assembly)
Figure 2
x 27