How To Operate Your Ceiling Fan; Maintenance; How To Clean Your Ceiling Fan Blades - Fanimation HUGH 44 Instructions Manual

How to Operate Your Ceiling Fan

1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 1)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
2. Wall control functiolns: (Figure 2)
Fan Speed Switch:
0: Power Off
1: Low Speed
2: Medium Speed
3: High Speed
Light Switch:
0: POWER OFF,
Turn switch counterclockwise to increase
light and clockwise to dim it.
3. If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Remove glass or plastic cap from light kit, then slide
the reverse switch inside the light kit assembly to the
opposite position reinstall glass or plastic cap.
Turn fan on again. (Figure 3 )
Reverse Switch Information
Season Rotation Direction
Summer Counterclockwise
Winter Clockwise
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
Abrasive cleaning agents are not required and should be
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Switch Position
Left
Right

Maintenance

How to Clean Your Ceiling Fan Blades

Light Kit
Assembly
Reversing
Switch
Do not use water when cleaning your ceiling fan. It
could damage the motor or the finish and create the
possibility of electrical shock.
Avoid using water, cleansers, or harsh rags, which
can
12
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
CAUTION