Fanimation HUGH 44 Instructions Manual page 11

How to Assemble Your Light Kit (continued)
6. Remove the three screws in the upper LED plate
assembly and retain the screws for later. (Figure 6)
(Option A--for use with light kit)
8A.
Connect the 2 single-pin connectors from the
plate assembly to the 2 single-pin connectors from lower
assembly. (Figure 8A)
LED plate
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
NOTE: If you have installed your fan with the plastic cap,
skip steps 9 and 10.
9. Assemble the lower LED plate assembly to the upper
LED plate assembly using the preousily removed screws
and securely tighten all three screws. (Figure 9)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
10. Secure the glass to light kit assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 10)
Upper LED Plate
upper LED
Upper LED
Plate Assembly
Lower LED Plate
Assembly
Light Kit
Assembly
Glass
11
Upper LED Plate
Assembly
Figure 6
Assembly
Light Kit Wire Cover
Figure 7
Lower LED Plate
Plastic Cap
Assembly
Assembly
Figure 8A
Figure 9
Figure 10
Light Kit Assembly
Figure 8B
Upper LED
Plate Assembly