Table of Contents
Advertisement
Chapter 6 Maintenance and Troubleshooting
Upgrading the Firmware
Upgrade from SFTP Server
The image file is on the SFTP server, and the file is /root/tp100_udp_1.0.5.bz2.
The server IP is
the default server mode, it does not need to be specified. Use the following
command:
tp100> upgrade firmware
/root/tp100_udp_1.0.5.bz2,192.168.81.74,root,123456
Upgrade from FTP Server
The image file is on the FTP server, and the file is /root/tp100_udp_1.0.5.bz2.
Server IP is
command:
tp100> upgrade firmware
/root/tp100_udp_1.0.5.bz2,ftp:192.168.81.75,root,ABCDEF
The system will show the upgrade progress as shown in the following example:
tp100> upgrade is in progress...
##########
After the system is finished getting the firmware file, you will see the following
system message:
tp100> upgrade is in progress...
########################################################
########################################################
###############################
Upgrade is successfully completed
tp100>
The entire process takes approximately three to five minutes. TimeProvider 100
continues normal operation during the upgrade process.
Switch Boot-Up Image File and Reboot the System
After the firmware upgrade is completed, use the
switch the boot-up image file to the newly upgraded image. See switchfirmware, on
page 59 for more information. To make the newly downloaded firmware active,
restart the TimeProvider 100 system using the
page 60.
tp100> switchfirmware
tp100> Reboot
90
TimeProvider 100 User's Guide
192.168.81.74,
, login:
192.168.81.75
login:
password:
root,
password:
root,
ABCDEF
switchware
command. See reboot, on
reboot
098-00106-000 Revision A – March, 2009
. Since SFTP is
123456
. Use the following
CLI command to
Advertisement
Table of Contents
