Cli Command Keyboard Usage - Symmetricom TimeProvider 100 User Manual

Chapter 5 CLI Commands
Overview
Vertical bars separate options.
| –

Italics indicates variable data.

All commands are completed by pressing the Enter key.


CLI Command Keyboard Usage

The interface has built-in features for navigating within the CLI command hierarchy
and are as follows:
Press the TAB key or type

commands.
Press the TAB key at any time while typing a command. TimeProvider 100 will

respond with the completion of the keyword or available completion choices
based on the letters you type.
– If typing of a keyword is partially complete, the completion will display if it
is unique, otherwise, completion choices will be available.
– If the keyword is complete after pressing the TAB key, the choices for the
next syntax element will display.
e1_ccs_no_ssm
e1_ccs4
e1_ccs4_no_ssm
e1_cas_no_ssm
e1_cas4
e1_cas4_no_ssm
e1_2048m
e1_ais
54 TimeProvider 100 User's Guide
at the prompt for a list of the available top-level
"?"
For example, typing
s
tp100> s
Then pressing the TAB key displays:
set - Changes settings
show - Displays settings
Continuing with the example, typing
TAB key, displays
set
command. Next, typing
displays
set output
completion. When typing
output signaltype
results in the signaltype options for
displaying as shown in the following:
- E1, CCS, CRC Disabled, Sa bits set to all 1's
- E1, CCS, CRC Enabled, SSM Enabled
- E1, CCS, CRC Enabled, Sa bits set to all 1's
- E1, CAS, CRC Disabled, Sa bits set to all 1's
- E1, CAS, CRC Enabled, SSM Enabled
- E1, CAS, CRC Enabled, Sa bits set to all 1's
- E1, 2.048 MHz
- E1, AIS
at the prompt displays:
and then pressing the
se
because it is the only possible
and then pressing the TAB key,
o
as the only possible command
and then pressing the TAB key,
s
displays. Finally, pressing the TAB key
set output signaltype
098-00106-000 Revision A – March, 2009
set