Symmetricom TimeProvider 100 User Manual page 80

Chapter 5 CLI Commands
Set Commands
Input:
tp100> set output port2 ?
Response:
state
frametype - Frame type
ssm-bit
tp100> set output port2
Input:
tp100> set output port2 frametype <tab>
Response:
e1_2048m
e1_cas4
e1_cas_no_ssm
e1_ccs4_no_ssm
tp100> set output port2 frametype
Input:
tp100> set output port2 frametype ?
Response:
e1_ccs_no_ssm
e1_ccs4
e1_ccs4_no_ssm
e1_cas_no_ssm
e1_cas4
e1_cas4_no_ssm
e1_2048m
e1_ais
tp100> set output port2 frametype
80 TimeProvider 100 User's Guide
- Output port state: enable or disable
- Specify SSM bit position, 4 through 8
e1_ccs4
e1_ccs_no_ssm
- E1, CCS, CRC Disabled, Sa bits set to all 1's
- E1, CCS, CRC Enabled, SSM Enabled
- E1, CCS, CRC Enabled, Sa bits set to all 1's
- E1, CAS, CRC Disabled, Sa bits set to all 1's
- E1, CAS, CRC Enabled, SSM Enabled
- E1, CAS, CRC Enabled, Sa bits set to all 1's
- E1, 2.048 MHz
- E1, AIS
e1_ais
e1_cas4_no_ssm
098-00106-000 Revision A – March, 2009