Symmetricom TimeProvider 100 User Manual page 52

Chapter 4 Operations
System Configurations
System configuration modification is done by using any of the CLI commands that
start with
set
restoration includes the following conditions:
The "Restore Factory" configuration is a full restore of the factory configuration

which includes the default IP configuration and default user data (user ID and
password).
The "Restore Backup" configuration restores configuration parameters set by the

operation from the backup FLASH, except for the IP configuration and user data
(user IDs and passwords).
The manual RESET button restores only the factory IP configuration and default

user data (user ID and password). The manual RESET button is located on the
back of the TimeProvider 100 unit. Press the RESET button and hold it for 3
seconds to perform the RESET.
52 TimeProvider 100 User's Guide
. See CLI Commands, on page 53 for more information. Configuration
098-00106-000 Revision A – March, 2009