Symmetricom TimeProvider 100 User Manual page 35

tp100> show ipstatus
MGMT
NTP
Setting IP Static Mode
Use the NTP port for static mode. The NTP port can only be set to static
mode. To set the IP settings with the following settings: IP address =
192.168.2.8, gateway = 192.168.2.1, and IP subnet mask = 255.255.255.0,
follow these steps:
1. Type and the following CLI command and then press Enter.
tp100> set ipconfig NTP ipaddr 192.168.2.8 mask 255.255.255.0 gateway 192.168.2.1
2. To make the settings available, type the following CLI command and then press
Enter:
tp100> set ipconfig NTP restart
Use values appropriate for your network environment.
Caution: After making configuration changes, you must use the set
configuration save CLI command to save the latest
configuration. See
information.
Confirm the setting and status by using the
commands. Use the
appropriate to your network. To confirm the IP address values, use the
CLI command. Refer to
ipconfig
56 for more information.
098-00106-000 Revision A – March, 2009
Link encap:Ethernet
inet addr:192.168.5.69
UP BROADCAST RUNNING MULTICAST
RX packets:519 errors:0 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:41055 (40.0 KiB)
Base address:0xa000
Link encap:Ethernet
inet addr:192.168.2.10
UP BROADCAST MULTICAST
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B)
Base address:0xc000
set configuration
set ipconfig
Chapter 2 Installation and Configuration
HWaddr 00:B0:AE:01:A4:AB
Bcast:192.168.5.255
MTU:1500
TX bytes:1938 (1.8 KiB)
HWaddr 00:B0:AE:01:A4:AA
Bcast:192.168.2.255
MTU:1500 Metric:1
TX bytes:84 (84.0 B)
, on page 72 for more
show ipconfig
CLI command to configure IP settings
TimeProvider 100 CLI Command
Configuration Setup
Mask:255.255.255.0
Metric:1
Mask:255.255.255.0
and
show status
show
Set, on page
TimeProvider 100 User's Guide 35