Table of Contents
Advertisement
Chapter 2
Configuration Setup
Setting IP DHCP Mode
In the following example, the MGMT port was used for configuration. After
configuration is done, type
1. Type the following CLI command and then press Enter.
tp100> set ipconfig MGMT mode dhcp
2. Type the following CLI command and then press Enter.
tp100> set ipconfig MGMT restart.
3. Type the following CLI command and then press Enter.
tp100> show ipconfig
Because the mode is DHCP, the dynamic IP address, gateway and subnet mask are
shown as
N/A
command,
show ipstatus
address is
192.168.5.69
Caution: After making configuration changes, you must use the set
configuration save CLI command to save the latest
configuration. See
information.
34
TimeProvider 100 User's Guide
show ipconfig
. In order to find out the real negotiated IP address, use the CLI
to check the current Ethernet status. In this case, the IP
and the IP subnet mask is
set configuration
to see a list of IP settings as shown.
255.255.255.0
, on page 72 for more
098-00106-000 Revision A – March, 2009
.
Advertisement
Table of Contents
