Chapter 5 CLI Commands
Set Commands
Response:
<longitude String 6 - 13> - GPS Position Longitude, format: Eddd:mm:ss.ss or
Wddd:mm:ss.ss
Input:
tp100> set gps mode manual latitude N89:56:10 longitude E130:00:00 height ?
Response:
<height String 1 - 7> - GPS position height in meter, format: hhhh.h
Note: TimeProvider 100 only accepts positive height. Negative
heights are not accepted.
Input:
tp100> set gps mode manual latitude N9:6:1 longitude E130:00:00 height 130
Response:
tp100>
set ipconfig
This command is used to configure the IP parameters of the management port and
future NTP port. The parameters are address, address acquisition mode, and
whether the port is enabled.
Input:
tp100> set ipconfig <tab>
Response:
MGMT
tp100> set ipconfig
Input:
tp100> set ipconfig ?
Response:
MGMT
NTP
tp100> set ipconfig
76
TimeProvider 100 User's Guide
NTP
- Management port
- NTP port
098-00106-000 Revision A – March, 2009