Table of Contents
Advertisement
1. Remove the fuse from the front panel of the Branch Circuit Over-Current
Protection Device. Replace the fuse at the end of the installation procedure.
2. Wire the provided Molex connector to 1 mm² / 18 AWG UL1007 wire with the
crimp pins supplied. Insert Molex pins into the Molex connector provided. Wire
the other end of the power wires to the Branch Circuit Over-Current Protection
Device.
3. Plug the Molex connector into the TimeProvider 100 and replace the fuse in the
Branch Circuit Over-Current Protection Device. The TimeProvider 100 -48/-60
nominal VDC power connector is keyed to only connect one way.
4. The connector has a latching mechanism. Push the connector in until it clicks into
place. When power is successfully provided, the LED labeled "PWR" will
illuminate green. Descriptions of LED indicators are shown in
Conditions, on page 88.
Note: When disconnecting, the latch arm needs to be tilted away from
the "catch" by pressing on the connector and then pulling.
Warning: To avoid serious personal injury or death, exercise caution
when working near high voltage lines and follow local building
electrical codes for grounding the shelf.
Establish Serial Communication
Serial communication with TimeProvider 100 is established so that configuration
can be accomplished. To establish serial communication, follow these steps:
1. Connect a serial cable from the computer's serial port with theTimeProvider
100's 9-pin serial port connector labeled RS232.
2. Run your terminal emulation program, and configure the designated COM port
on the computer using
Table 2-1. COM Port Properties
Bits per second
Data bits
Parity
Stop bits
Flow control
098-00106-000 Revision A – March, 2009
Table
2-1.
Settings
Chapter 2 Installation and Configuration
Value
9600
8
None
1
None
Configuration Setup
Reading LED
TimeProvider 100 User's Guide
31
Advertisement
Table of Contents
