Table 4-2. Settable Options Description - Fujitsu m2488 User Manual

CONFIGURATION
Navigation keys:
To navigate through the options, settings, and to make changes from the Operator Panel:
Press START to move forward through the options or settings. It will also increment the settings num-
bers.
Press SHIFT and START to move backward through the options or settings. It will also decrement the
settings numbers.
Press RESET to move from settings to option or to leave setting mode.
Press TEST to move from the option to settings.
Press UNLOAD to select a number field for multiple digit numbers.
Setting Procedure:
Remove all cartridges and magazine prior to performing this procedure.
Step 1. Press and hold both the TEST and UNLOAD keys, wait for OFFLINE to be displayed then
release both keys.
main Off-line menu will be displayed. (Keys must be held for approximately 2 seconds
before Off-line mode is entered.)
Press the START pushbutton until SETTING is displayed. The settable options are
Step 2.
described in Table 4-2.
Step 3. Press the TEST pushbutton.
Step 4. The first option, 70: S.TAR, is displayed. Press TEST to view the setting or START to
view next option.
Step 5. The settings may be saved at option 89: WTROM.
Step 6. When options are set and saved, press RESET twice to return to
a. If there is an outstanding SCSI command or if there is a tape loaded in the tape drive then Off-line
mode cannot be entered.
OPTION SETTINGS
70: S.TAR TARGID: 0
71: S.LUN LUN: 0
72: S.LNG ENGLISH
FRENCH
GERMAN
SPANISH
ITALIAN
73: S.RDY BOTRDY:N
4-2
a
Once the keys are released then the first item, DIAGMODE, in the

Table 4-2. Settable Options Description

The SCSI target ID assigned to the M2488 system.
The logical unit number assigned to the tape drive.
Select the language of the fixed display messages.
If N, the BOT RDY message is not displayed on the operator panel
Y when the cartridge is loaded and positioned at the physical load
point.
If Y, the BOT RDY message is displayed on the operator panel when
the cartridge is loaded and positioned at the physical load point.
CG00000-011403 REV. A
DESCRIPTION
M2488 USER'S GUIDE
or N.
DEFAULT
SETTINGS
0
0
ENGLISH
N
April 1997