Fujitsu m2488 User Manual page 55

M2488 USER'S GUIDE
OPTION SETTINGS
74: S. N N: NO
YES
75: S.ITS INTEN: 0
76: S.ACL ACL:AUTO
SYS
77: S.FT1 S.FT1: 00
78: S.FT2 S.FT2: 00
79: S.FT3 S.FT3: 00
80: S.FT4 S.FT4: 00
81: FSGRP NONE
FSGRP S
FSGRP T
FSGRP U
FSGRP V
FSGRP W
FSGRP X
FSGRP Y
FSGRP Z
82: S.SDT SDTR: N
83: S.WDT WDTR: N
84: S.FT5 S.FT5: 00
85: LIBRY NONE
KOALA
ATL
86: S.MCL MCL: 4
89: WTROM WTROM: Y
April 1997
Table 4-2. Settable Options Description (Continued)
If NO, the drive's Target ID is not displayed when no cartridge is
loaded.
If YES, the drive's Target ID is displayed when no cartridge is dis-
played.
Adjusts intensity of the Operator Panel display. 0 is brightest, 3 is
darkest.
Select the automatic or system mode for the medium changer at
power up. If a medium changer is not installed, this setting has no
effect on unit operation.
Sets an additional function. The bits are described in Table 4-3.
Sets an additional function. The bits are described in Table 4-4.
Sets an additional function. The bits are described in Table 4-5.
Sets additional functions. The bits are described in Table 4-6.
Selects a feature setting group. Each group enables a subset of the
features controlled by the FT1 through FT5 settings.
A feature can be enabled either by a feature group or by setting the
appropriate values in the FT1 through FT5 settings.
A feature is disabled only if both the feature group and the FT1
through FT5 settings are not enabled.
The actual features for each group are not specified in this manual.
If N, the target will not initiate a Synchronous Data Transfer Request
Y If Y, the target will initiate a Synchronous Data Transfer Request if
the initiator does not.
If N, the target will not initiate a Wide Data Transfer Request
Y If Y, the target will initiate a Wide Data Transfer Request if the initia-
tor does not.
Sets additional functions. The bits are described in Table 4-7.
Selects a Library Interface setting. This option is used by Manufac-
turing to configure and enable a Library RS-232 Interface port on the
tape drive for attachment to a particular tape Library.
Medium changer logical address.
If Y, the setting data is written to the nonvolatile memory.
N If N, the setting data is not written to the nonvolatile memory.
CG00000-011403 REV. A
DESCRIPTION
CONFIGURATION
DEFAULT
SETTINGS
NO
0
AUTO
00
00
00
00
NONE
N
N
00
NONE
4
Y
4-3