Configuration; Chapter Introduction; Setting Menu; Table 4-1. Operator Panel Top Level Menus - Settings - Fujitsu m2488 User Manual

M2488 USER'S GUIDE
4-1

CHAPTER INTRODUCTION

This chapter provides information on the following subject areas:

4-2 SETTING MENU

4-3 LOADING NEW FIRMWARE
4-4 DRIVE INFORMATION
4-5 MODE PAGE SETTINGS
4-2 SETTING MENU
This procedure describes the steps required to access and configure the user settable options. All dis-
plays refer to the Operator Panel display on the M2488 tape drive or the medium changer. The menu
structure is shown below with the SETTING menu shaded:
TEST and UNLOAD pressed
* →
OFFLINE
April 1997
CHAPTER 4

CONFIGURATION

Table 4-1. Operator Panel Top Level Menus - Settings

TEST and UNLOAD released
→
DIAGMODE
↓
START
SETTING
LOADCODE
INQUIRY
MODE PGS
FACTORY
CG00000-011403 REV. A
Selection and execution of off-
line diagnostics
TEST
Access and configure user
→
settable options
Copy new firmware from a code
image tape cartridge into non-
volatile memory of M2488.
View M2488 Information
Display or change selected Tape
Unit or Medium-Changer Mode
Pages
Change factory mode settings,
enable factory mode, or enable
factory diagnostics.
CONFIGURATION
Product Guide
Section 8-4
User's Guide
Section 4-2
User's Guide
Section 4-3
User's Guide
Section 4-4
User's Guide
Section 4-5
Product Guide
Section 8-5
4-1