Remove the non-hot-plug drive.
12.
To replace the component, reverse the removal procedure.
Front panel LED
To remove the component:
Unlock and remove the tower bezel
1.
Power down the server (on page 23).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
4.
Remove the access panel (on page 24).
5.
If installed, remove the PCI air baffle (on page 25).
6.
Remove the system air baffle (on page 24).
7.
Remove the fans (on page 25).
8.
("Remove the tower
bezel" on page 23).
Removal and replacement procedures 30