Disconnect the front USB module cable from the system board.
8.
Remove the front USB module.
9.
To replace the component, reverse the removal procedure.
Front panel LED/buttons module
To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Remove the front bezel (on page 26).
3.
Place the server on its side.
4.
Remove the access panel
5.
If installed, remove the PCI air baffle
6.
("Access
panel" on page 26).
("PCI air
baffle" on page 27).
Removal and replacement procedures 29