Control Panel; Features; Overview - ABB ACS850 User Manual

10

Control Panel

Features

The Control Panel features:
• alphanumeric control panel with an LCD display
• copy function – parameters can be copied to the control panel memory for later
transfer to other drives or for backup of a particular system.
• context sensitive help
• real time clock.

Overview

The following table summarizes the key functions and displays on the Control Panel.
1
2a
LOC 30.00rpm 30.10Hz
30.00rpm
LOC 400RPM
49 . 10
1200 RPM
0 . 50
2b
12.4 A
10 . 7
405 dm3/s
2c
DIR DIR 00:00 12:45 MENU
3
5
7 6
9
Hardware description
No. Use
1 Status LED – Green for normal operation.
2 LCD display – Divided into three main areas:
a. Status line – variable, depending on the mode of operation, see section
Hz
Status line
A
b. Center – variable; in general, shows signal and parameter values, menus or
lists. Shows also faults and alarms.
%
c. Bottom line – shows current functions of the two soft keys and, if enabled,
MENU
the clock display.
3 Soft key 1 – Function depends on the context. The text in the lower left corner
4
of the LCD display indicates the function.
4 Soft key 2 – Function depends on the context. The text in the lower right
8
corner of the LCD display indicates the function.
5 Up –
10
• Scrolls up through a menu or list displayed in the center of the LCD display.
• Increments a value if a parameter is selected.
• Increments the reference value if the upper right corner is highlighted.
Holding the key down changes the value faster.
6 Down –
• Scrolls down through a menu or list displayed in the center of the LCD
display.
• Decrements a value if a parameter is selected.
• Decrements the reference value if the upper right corner is highlighted.
Holding the key down changes the value faster.
7 LOC/REM – Changes between local and remote control of the drive.
8 Help – Displays context sensitive information when the key is pressed. The
information displayed describes the item currently highlighted in the center of
the display.
9 STOP – Stops the drive in local control.
10 START – Starts the drive in local control.
on page 11.