How To Set The Speed, Frequency, Torque Or Position Reference In The Output Mode; How To Adjust The Display Contrast - ABB ACS850 User Manual

20

How to set the speed, frequency, torque or position reference in the Output mode

See also section
Step Action
1. If you are not in the Output mode, press
2. If the drive is in remote control (REM shown on the status line), switch to local
control by pressing
the mode and then returns to the Output mode.
3. • To increase the highlighted reference value shown in the top right corner of the
display, press
permanent memory of the drive and restored automatically after power switch-
off.
• To decrease the value, press

How to adjust the display contrast

Step Action
1. If you are not in the Output mode, press
2. • To increase the contrast, press keys
• To decrease the contrast, press keys
Operation
Reference Edit
EXIT
. The display briefly shows a message about changing
LOC
REM
. The value changes immediately. It is stored in the
.
EXIT
MENU
and
MENU
and
on page 44.
repeatedly until you get there.
repeatedly until you get there.
simultaneously.
simultaneously.
Display
REM 30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
LOC 30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
LOC 31.00rpm
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
Display
LOC 30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU
LOC 30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
DIR 00:00 MENU