Assistants; How To Use An Assistant - ABB ACS850 User Manual

28

Assistants

When the drive is first powered up, the Start-up Assistant guides you through the
setup of the basic parameters. The Start-up Assistant is divided into assistants, each
of which is responsible for the specification of a related parameter set, for example
Motor Set-up or PID Control. The Start-up Assistant activates the assistants one
after the other. You may also use the assistants independently.
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.

How to use an assistant

The table below shows the basic operation sequence which leads you through
assistants. The Motor Set-up Assistant is used as an example.
Step Action
1. Go to the Main menu by pressing
EXIT
by pressing
2. Go to the Assistants mode by selecting ASSISTANTS on the menu with keys
and
3. Motor Set-up assistant under Firmware assistants is used as an example.
Select Firmware assistants with keys
4. Select Motor Set-up with keys
If you select any other assistant than the Start-up Assistant, it guides you
through the task of specification of its parameter set as shown in steps
below. After that you can select another assistant on the Assistants menu or exit
the Assistants mode.
5. Select the appropriate type with keys
6. • To accept the new value and continue to the setting of the next parameter,
SAVE
press .
• To stop the assistant, press
Operation
MENU
if you are in the Output mode, otherwise
repeatedly until you get to the Main menu.
ENTER
, and pressing .
and
EXIT
.
SEL
and , and press
OK
, and press .
and .
Display
LOC MAIN MENU
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT 00:00
LOC ASSISTANTS
Firmware assistants
Application assistant
EXIT 00:00
LOC CHOICE
Select assistant
.
Application Macro
Motor Set-up
EXIT 00:00
LOC
PAR EDIT
9904 Motor type
AM
5. and 6.
[0]
EXIT 00:00
LOC PAR EDIT
9904 Motor type
PMSM
[1]
EXIT 00:00
LOC
PAR EDIT
9905 Motor ctrl mode
DTC
[0]
EXIT 00:00
1
ENTER
1
SEL
OK
SAVE
SAVE
SAVE